The S2 is a lunchbox-sized spa day for soggy filament, and reviewers keep being surprised how much dryer they get for the money.
Damp filament causes stringing, bubbling and rough surfaces. A dryer warms the spool gently to drive the moisture out. The S2 is the simple, budget way to do it.
Our verdict: if you print one material at a time and want a straightforward dryer, this is a solid pick. If you swap between several spools daily, a multi-spool unit will frustrate you less.
Pros
- Arrives fully assembled
- Maximum temperature of 70°C, high for a budget dryer
- Clear 4.6 inch display showing humidity, temperature and time
- Power draw under 50 W, with a listed maximum of 48 W
- Can dry while you print
Cons
- Holds one 1 kg spool
- Lid has no gasket or locking mechanism
- Basic airflow and a plastic exterior
- Minimal accessories
What the internet says
A summary of public reviews, forum threads and owner feedback we read, as of 17 November 2026. These are other people's opinions, linked at the bottom.
What people love
- Reviewers praise how much dryer you get for the money
- Reddit commenters often recommend SUNLU dryers: the brand scores 4.1 across 99 mentions in one roundup of Reddit opinion
- Easy setup, clear display and low power draw
What people complain about
- One Reddit user found the fan too loud (the S2 scores 4.0 in that roundup)
- Holds only one spool
- Lid has no gasket or locking mechanism
The consensus: A crowd favourite brand, and the S2 is the cheap, simple one. Most complaints are about limits, not failures.
See today's price for the SUNLU FilaDryer S2 on Amazon → (affiliate link)
What the reviews say
Reviewer Phonograph found the S2 simple to set up, well built for the price and easy to use, and reported no moisture symptoms or print flaws in test prints after drying old filament. Its criticisms were the single-spool capacity, the ungasketed lid, the basic airflow and the minimal accessories.
Our take
For most home makers, one good dryer and sealed storage is plenty. Check the recommended drying temperature for your filament, as some materials need more than 70 °C.
Who it isn't for
- Anyone who needs to dry several spools at once
- People who want a sealed, gasketed box for long-term storage
Specifications
| Maximum temperature | 70 °C |
|---|---|
| Maximum power | 48 W |
| Display | 4.6 inch LCD |
| Capacity | One 1 kg spool (per review) |
| Product size | 265 × 274 × 118 mm |
| Net weight | 1,109 g |
Manufacturer figures. We have not bench-tested these.
Alternatives
- Creality Space Pi V2higher temperature range, presets and a longer timer
Questions
What temperature should I dry filament at?
Use the filament maker's recommendation. It varies by material, and some need more than a 70 °C unit can supply.
Do I need a dryer for PLA?
Often not, if it is stored sealed. A dryer helps if a spool has been left out in humid weather.
What we read
This is a research review. We have not tested the product ourselves. Our opinions are based on these sources: