It's a pair of tiny cutters, and it's the thing you'll reach for most at a 3D printing bench. Cheap, cheerful and hard to argue with.
Every 3D printing bench needs a flush cutter for trimming filament ends, removing supports and cleaning up tabs. The CHP-170 is a widely used, low-cost choice: an angled 8 mm head, rated for copper and soft wire up to 16 gauge (1.3 mm), in heat-treated carbon steel.
Our verdict: a sensible, low-cost cutter for routine bench work and a better bet than anonymous bundled nippers. Premium cutters feel nicer, but cost more.
Pros
- Angled head for flush cuts
- Rated for soft wire up to 1.3 mm
- Known brand and inexpensive
- Durable enough for regular use, per the review
Cons
- Light trimming only
- Less refined than premium cutters
- Will not replace deburring or sanding
What the internet says
A summary of public reviews, forum threads and owner feedback we read, as of 17 November 2026. These are other people's opinions, linked at the bottom.
What people love
- A recognised brand at a low price
- Clean flush cuts for filament, supports and zip ties
- Considered a better bet than anonymous bundled nippers
What people complain about
- Light trimming only
- Less refined than premium cutters
- Won't replace deburring or sanding
The consensus: Cheap, cheerful and hard to argue with. Few complaints, mostly about its limits.
See today's price for the Hakko CHP-170 micro cutter on Amazon → (affiliate link)
What the reviews say
Good Prints 3D describes it as good for trimming filament, snipping light supports and cleanup tabs, cutting zip ties and small plastics, and recommends it for starter benches and shared spaces. It says it is not the tool for heavy wire or for very tight, premium-finish work.
Who it isn't for
- Anyone who already owns a premium cutter
- People cutting hard wire or thick materials
Specifications
| Jaw length | 8 mm |
|---|---|
| Cutting capacity | up to 16 gauge (1.3 mm) soft wire |
| Construction | Heat-treated carbon steel |
Manufacturer figures. We have not bench-tested these.
Questions
Can I use it on hard wire?
No. It is rated for soft wire and copper. Hard wire can damage the jaws.
Do I need a deburring tool as well?
It helps for cleaning edges after trimming.
What we read
This is a research review. We have not tested the product ourselves. Our opinions are based on these sources: